Bennett Trim Tabs

[Pedlyr]

I would look at the prop and gear. With a power increase you might have to change a few things. Now you get into prop clearance, shaft size, and reduction...

[Pedlyr]

Bennett trim tab motor toast. got wet. Got it working but its a mess and probably wont last. Motor itself is a DCM D-004-400. Cant find one anywhere....

[Pedlyr]

I have used this company before for larger commercial boat shaft repair. I would give them a call.

https://acbprop.com/about-us/...

[Pedlyr]

Where are you located? You could have one Monday morning if you drove there

https://www.defender.com/product.jsp?id=4014653

[Pedlyr]

Neutral and grounds mixed is a very common problem. Especially when shore power or 3 phase is involved. But even when everything is perfect I still dont...

[Pedlyr]

We have had this discussion on here before. I am not an electrician. But I deal with boat wiring all the time. Even when wired correctly, GFI outlets...

[Pedlyr]

I have actually been there a few times. The shop is above a garage and set up very well, but small. Guys are very close when working. Too bad, they were...

[Pedlyr]

If you chewed up your impeller pieces may have migrated and are restricting flow. Like at the gear oil cooler...

[Pedlyr]

Make sure screen where fuel line goes into carb is clear. Dont ask me how I know that

[Pedlyr]

Dont even have to paint it

https://www.generalpropeller.com/buc...rms/10TA10X700

This is what I use for dissimilar metals. Works...